HULK POWER HP02W004S1 Manuel d'utilisation et d'entretien télécharger pdf (Page 5)

SPECIFICATIONS & ELECTRICAL INFORMATION

WARNING

ALL ELECTRICAL INSTALLATIONS MUST BE PERFORMED BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY

RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE PERFORMED WITH THE COMPRESSOR

DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!

POWER SUPPLY

WARNING: YOUR COMPRESSOR MUST BE CONNECTED TO A 110V,

WITH A MINIMUM 15-AMP. BRANCH CIRCUIT. FAILURE TO CONNECT

IN THIS WAY CAN RESULT IN INJURY FROM SHOCK OR FIRE.

GROUNDING

Your compressor must be properly grounded. Not all outlets are properly

grounded. If you are not sure if your outlet is properly grounded, have it

checked by a qualified electrician.

WARNING: IF NOT PROPERLY GROUNDED, THIS COMPRESSOR

CAN CAUSE ELECTRICAL SHOCK, PARTICULARLY WHEN USED IN

DAMP LOCATIONS. TO AVOID SHOCK OR FIRE, IF THE POWER CORD

IS WORN OR DAMAGED IN ANY WAY, HAVE IT REPLACED IMMEDI-

ATELY.

If this compressor should malfunction or breakdown, grounding provides a

path of least resistance for electric current, to reduce the risk of electric

shock. This compressor is equipped with a cord having an grounding

conductor and grounding plug. The plug must be plugged into an

appropriate outlet that is properly installed and grounded in accordance

with all local codes and ordinances.

WARNING: TO MAINTAIN PROPER GROUNDING, DO NOT REMOVE OR

ALTER THE GROUNDING PRONG IN ANY MANNER.

110V OPERATION

As received from the factory, your compressor is ready to run for 110V

operation. This machine is intended for use on a circuit that has an outlet

and a plug which looks like the one illustrated in Fig.1.

WARNING: DO NOT USE A TWO-PRONG ADAPTOR FOR THEY ARE

NOT IN ACCORDANCE WITH LOCAL CODES AND ORDINANCES.

NEVER USE IN USA.

FIGURE 1

LENGTH OF

CONDUCTOR

0-25 FEET

26-50 FEET

51-100 FEET

WIRE SIZES REQUIRED

(AMERICAN WIRE GAUGE)

110V LINES

NO.12

NO.10

FIGURE 2

EXTENSION CORDS

The use of any extension cord will cause some loss of power. IT

IS RECOMMENDED TO USE A LONGER AIR HOSE INSTEAD

OF AN EXTENSION CORD. If you do not have a choice, use the

table in Fig.2 to determine the minimum wire size

(A.W.G-American Wire Gauge) extension cord. Use only 3-wire

extension cords which have 3-prong grounding type plugs and

3-hole receptacles which accept the tool’s plug.

For circuits that are further away from the electrical circuit box, the

wire size must be increased proportionately in order to deliver

ample voltage to the compressor motor. Refer to Fig.2 for wire

length and size.

PROPERLY GROUNDED OUTLET

CURRENT CARRYING

PRONGS

GROUNDING

PRONG

SPECIFICATIONS

Model ................................................................................................................................................................................HP02W004S1

Voltage ............................................................................................................................................................................................110V

Horsepower ....................................................................................................................................................................................2HP

Amperage ......................................................................................................................................................................................11.5A

RPM (no load speed)

.....................................................................................................................................................................1720

Phase .

...................................................................................................................................................................................................1

Hertz

..............................................................................................................................................................................................60Hz

Operating pressure

..................................................................................................................................................................125 PSI

Tank size

..............................................................................................................................................................................4 GALLON

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire

HULK POWER HP02W004S1 Manuel d'utilisation et d'entretien Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Compresseurs d'air HULK POWER HP02W004S1